DC-UPS for batteries, primary : 24 V, secondary : 24 V, output: 20 A, dimensions: 123x65x141 mm, weight: 0.8 kg
Availability : 1-2 weeks
UPSOTEC 2420
Availability : 1-2 weeks
UPSOTEC 2420
DC-UPS for batteries, primary : 24 V, secondary : 24 V, output: 20 A, dimensions: 123x65x141 mm, weight: 0.8 kg
| Input | |
| Nominal Input voltage | 24 V DC (22...30 V DC) SELV |
| Min. nominal input voltage for charching operation | 22,5 V DC +/-2% |
| Output | |
| Nominal output voltage mains operation | 27,7...19,2 V DC |
| Nominal output voltage back-up operation with temperature tracking | 24 V DC (22...30 V DC) |
| Max. nominal output voltage | 20 A |
| In General | |
| Protective system | IP20 |
| Operational temperature | -25°C...50°C |
| Dimensions | 123 x 65 x 141 mm |
| Weight approximately | 0,8 kg |
The DC UPS series UPSOTEC is capable to provide an uninterruptible power supply as well with batteries as with ultracapacitors. All CEM modules (24 V DC) as well as the battery modules up to 40 Ah can be used in combination with the UPSOTEC series.
The UPSOTEC is the right way to back up a power failure without failures and downtimes in production.
An externally connected battery allows backup times up to the hours. However, if only a short back up time and a maintenance-free energy storage is needed, which is also suitable for high temperatures, the choice falls on an ultracapacitor module.
The DC-UPS UPSOTEC includes a charging and monitoring system inside the housing, which charges the externally connected energie store. The UPS is supplied by an external regulated DC power supply. In case of an interruption of the DC supply, the energy of the energie store is released unregulated. The load is supplied from the UPS until the voltage drops below the deep discharge limitation. The back-up time depends on the state of charge of the energie store and on the discharge current.
